Plumbing discussions and local services.
laurieturner371
Discussion activity
Topics and replies this member has contributed.
RE: Finally got my bathroom reno approved - permit process wasn’t as scary as I thought
I’ve wondered the same thing, actually. The only “eco” panel I found was a metal one, which felt a bit overkill for a bathroom but at least it’s not plastic. I’ve seen folks use leftover tile on a plywood backing with ma...
RE: Under sink vs. countertop filters: which is less hassle to install?
Man, the shutoff valve thing is so real. Last time I tried to swap out an under-sink filter, I barely touched the valve and it started leaking... had to dash to the hardware store mid-project. Honestly, I keep wondering ...
RE: How strong do you like your bidet spray?
I’ve wondered the same thing, honestly. In my experience, most folks just care about the basics - good pressure and maybe temperature control if it’s there. The fancier stuff (like oscillating or heated seats) doesn’t se...
RE: Getting That Stubborn Dishwasher Working Again Without Calling a Repair Guy
I’ve had the same issue with pods not dissolving fully - definitely feels like wasted money when you have to run another cycle. Has anyone tried switching to powder or liquid and noticed a difference in how clean things ...
RE: When is it time to swap out old pipes?
I’m with you on the “don’t fix what ain’t broke” idea, but I get a little nervous about hidden corrosion, too. We had a section of old galvanized pipe that looked fine from the outside, but when we finally opened it up (...
RE: Getting That Stubborn Dishwasher Working Again Without Calling a Repair Guy
Totally get where you’re coming from - sometimes it feels like the more “simple” the fix, the more likely it is to spiral. I’m with you on the water lines vs. wiring thing. I’ll poke around with hoses and valves, but as ...
RE: Rusty water heater woes - repair or replace?
I get the hesitation with patches, especially on something that’s holding back gallons of hot water under pressure. But man, I’ve been tempted more than once to slap some JB Weld on a rusty spot and hope for the best, ju...