Plumbing discussions and local services.
donaldsailor
Discussion activity
Topics and replies this member has contributed.
RE: How often do you actually test your main water shut-off?
I hear you on the ball valves - they're way better than those old gate valves, but yeah, they can still seize up if ignored. I’ve run into a few that needed a wrench and some elbow grease to get moving again. Out of curi...
RE: Finally got rid of those kitchen clogs for good
Yeah, I hear you on the enzyme cleaners being slow sometimes. I’ve had to bust out the snake more than once when things got really backed up. Ever tried combining both - like enzymes for maintenance and the snake for eme...
RE: Why do faucet handles turn opposite ways?
Yeah, the lack of consistency with faucet handle directions can drive you nuts, especially when you're used to one setup and then run into a totally different one on the next job. I’ve had a few situations where I though...
RE: Under Sink Hookup vs. Dedicated Drain Line: Which Is Better for Dishwashers?
I hear you on the habits part - seen plenty of folks blame the plumbing when it’s really just years of dumping stuff they shouldn’t. Still, I’ve noticed dedicated lines can save headaches in older houses with finicky pip...
RE: My Pipes Burst at 2 AM - Ever Had a Midnight Plumbing Nightmare?
Heat’s definitely helped me out a couple times, especially when the valve’s just gummed up from years of not being touched. Hair dryer is about as risky as I’d go, too - seen too many folks try a torch and end up with sc...
RE: Why does swapping out a busted ice maker cost so much?
Been there... I used to think those copper lines were solid until I saw one kink and split behind a fridge. Since then, it’s braided steel or nothing. Haven’t seen anything better yet, honestly. Maybe overkill, but I’ll ...
RE: why is documenting plumbing connections such a nightmare?
Yeah, I totally get where you’re coming from. I’ve lost count of how many times I’ve found a faded diagram or a mystery tag buried behind drywall. That’s why I liked your point about heat-shrink tubing - those things are...