Funny timing—I just finished installing a touchless faucet in our kitchen last weekend. I thought I was being clever by mounting the sensor higher up to avoid the cat triggering it, but now it barely picks up my hands unless I’m practically waving at it. The battery thing tripped me up too; I ended up putting a sticky note inside the cabinet with the install date so I’ll remember to swap them out. Has anyone tried the hardwired versions? I’m wondering if they’re worth the extra hassle or if they come with their own set of headaches...
I thought I was being clever by mounting the sensor higher up to avoid the cat triggering it, but now it barely picks up my hands unless I’m practically waving at it.
Honestly, this is why I skipped touchless altogether and just went with a single-lever faucet. Less tech, less to break, and no batteries or wiring to worry about. Plus, I’m not convinced the extra electronics are all that eco-friendly in the long run. Have you noticed any water savings, or is it mostly just for convenience?
I’ve installed a fair share of touchless faucets, and honestly, the water savings really depend on how folks use them. In theory, they should help by shutting off automatically, but I’ve seen people just wave their hands around trying to get the sensor to work, which kind of defeats the purpose. Batteries dying at the worst time can be a pain too. Do you ever run into issues with temperature control on single-lever models, or is that pretty straightforward for you?
I’ve noticed the same thing with sensors—sometimes they’re just too sensitive or not enough, and you end up doing a weird hand dance to get water. For the single-lever models, I find temperature control is usually okay, but if my hands are wet or soapy, it can get slippery and tricky to adjust. I’m curious, though—has anyone tried those models where you can preset the temp? Wondering if that actually helps with both comfort and water savings, or if it’s just another gimmick...
- Preset temp models are popping up more, but honestly, they’re not a magic fix.
- You can set a “comfort zone,” which is nice if you hate fiddling with levers, but the actual water temp can still fluctuate depending on your plumbing and pressure.
- In terms of water savings, it’s hit or miss. If you’re not waiting for the right temp every time, maybe you save a bit, but leaks or sensor misfires can cancel that out fast.
- Maintenance-wise, more parts = more things to break down the line. I’ve replaced a few thermostatic cartridges already... not cheap.
- Personally, I’d rather have a solid manual mixer than trust another electronic part to go weird on me.