Notifications
Clear all

my shower's gone rogue and sprays everywhere but down

430 Posts
407 Users
0 Reactions
2,539 Views
Posts: 2
(@johnhawk321)
New Member
Joined:

"Turns out the plastic threads inside had worn down just enough to mess up the alignment."

Yeah, that's exactly why I steer clear of plastic fittings whenever possible. Sure, they're cheaper upfront, but metal threads hold up way better over time. Learned that lesson after my kitchen faucet went rogue...

Reply
Posts: 6
(@rubyrain207)
Active Member
Joined:

Haha, your shower sounds exactly like mine did a couple months back. Ever tried shampooing your hair while dodging rogue water jets? Not fun. Turns out mine had the same issue:

"Turns out the plastic threads inside had worn down just enough to mess up the alignment."

I mean, who knew plastic threads could betray you like that? I swapped mine out for metal fittings too, and it's been smooth sailing ever since. But seriously, why do manufacturers even bother with plastic fittings in places that get constant use and pressure? Is it just to keep plumbers employed or something? Anyway, lesson learned—metal fittings are worth the extra few bucks. Now if only I could convince my bathroom sink to stop dripping...

Reply
mfluffy30
Posts: 7
(@mfluffy30)
Active Member
Joined:

Yep, plastic fittings strike again. Couple quick thoughts:

- Plastic parts are cheap for manufacturers and lighter for shipping, so it's mostly cost-cutting. Metal fittings add weight and cost, which hurts their profit margins.
- Agree 100% on metal fittings—worth every penny. They just hold up better under constant pressure.
- For your sink drip, have you checked the washer or cartridge yet? Usually that's the culprit...

"Ever tried shampooing your hair while dodging rogue water jets?"

And yeah, been there...felt like a ninja training session every morning. Glad you got it sorted!

Reply
ruby_smith
Posts: 3
(@ruby_smith)
New Member
Joined:

Metal fittings add weight and cost, which hurts their profit margins.

Haha, the ninja training comment hits home. Had a tenant once who called me in a panic because the showerhead literally popped off mid-shampoo—plastic fitting snapped clean off. Lesson learned: metal fittings from then on. Curious though, did swapping the washer fix your sink drip?

Reply
sam_cyber
Posts: 6
(@sam_cyber)
Active Member
Joined:

Totally agree on metal fittings—yeah, they're pricier upfront, but trust me, you'll save yourself from surprise shampoo disasters down the line. Plastic fittings are basically ticking time bombs waiting to snap at the worst possible moment (usually mid-shower, eyes full of soap...). Plus, metal threads hold up way better if you ever need to swap out showerheads or fix leaks. And about that sink drip, swapping washers usually does the trick, but sometimes it's the valve seat that's worn down. Worth checking if it keeps dripping.

Reply
Page 57 / 86
Share:
Scroll to Top