Medium setting is where it’s at for me too. I used to crank it up thinking I was getting a “power wash” down there, but all I got was a cold surprise and a leaky shutoff valve. Not to mention, my water bill didn’t thank me either. I figure if you need firehose pressure, something else is probably wrong… or you’re just showing off for the plumbing gods. Medium gets the job done, saves water, and keeps the bathroom floor dry—win-win.
Medium gets the job done, saves water, and keeps the bathroom floor dry—win-win.
- Couldn’t agree more on the water bill part.
- High pressure just wastes water and honestly, it’s not great for the pipes either.
- Medium’s plenty—clean, efficient, and no accidental “bidet fountain” in the bathroom.
- If you need more than that, maybe time to check your diet...
Medium’s usually the sweet spot, yeah. I’ve seen folks crank it up thinking more pressure means cleaner, but all you get is a soaked floor and maybe a call to fix a leaky valve later. Ever notice how high pressure just rattles old pipes? Not worth the mess or the repair bill.
I get where you’re coming from about the risk of leaks and rattling pipes, but I’m not totally convinced medium is always the best for everyone.
- Some folks (like me) have low-flow plumbing already, so even “high” on the bidet isn’t exactly a firehose. I’ve never had an issue with leaks or anything, and I check for drips pretty regularly.
- If you’re using a bidet to cut down on toilet paper, a slightly stronger spray can actually help you use less water overall. Less time spent rinsing, less waste. That’s a win for the environment, at least in my book.
- Old pipes are definitely a concern, but if your plumbing’s that fragile, you might want to look at the bigger picture. A gentle spray won’t save you from a burst pipe if things are already corroded.
I do agree that cranking it up to max is asking for trouble (and a wet bathroom floor). But I think there’s some wiggle room between “medium” and “disaster.” Maybe it’s just about knowing your own setup and not assuming one setting fits all.
Funny enough, my partner likes it way gentler than I do—says anything more than a trickle feels like a pressure washer. Meanwhile, I’m over here thinking the higher setting is just efficient. Guess it’s one of those things where personal comfort and your house’s quirks both matter.
Anyway, I’d say experiment a bit, but keep an eye on your pipes if they’re older. And maybe don’t trust the “max” setting unless you’re ready for a surprise...
I get what you’re saying about low-flow plumbing making “high” less intense, but I’d still be careful. Even with newer pipes, the fittings on some bidet attachments aren’t always top-notch.
True, but a stronger spray can speed up wear on seals and washers, especially if you use it a lot. Ever had to replace those tiny rubber gaskets? Not fun. I usually keep mine just below medium—enough pressure to be effective, but not enough to stress the connections. Maybe I’m just paranoid after dealing with a slow leak that went unnoticed for weeks...A gentle spray won’t save you from a burst pipe if things are already corroded.
