Honestly, cranking up the spray doesn’t really use more water—most bidets just shoot the same amount, just with more pressure. If you’re worried about leaks, though, keep it gentle. Trust me, I’ve seen what happens when old pipes meet overzealous settings... not pretty.
I totally get what you mean about the old pipes—been there, had the mini flood, not fun. You’re right that most bidets just up the pressure, not the actual water usage. I did a little test with a measuring cup once (don’t judge), and it was pretty much the same amount no matter the setting. Still, I keep mine on the lower side just in case. Better safe than mopping up the bathroom floor, right?
I’ve always wondered if those pressure settings are just psychological… like, is the “jet” mode really doing more, or is it just making me flinch? I tried the high setting once and nearly launched myself off the seat, so now I stick to low or medium. Anyone ever had issues with the fittings leaking when you crank it up? I get nervous messing with old plumbing—my house is basically a museum of questionable pipe decisions.
“my house is basically a museum of questionable pipe decisions.”
That line hit home. I used to think the “jet” mode was just for show, but after dealing with some ancient plumbing, I’m convinced it’s more than psychological—crank it up and you’ll find out real quick if your fittings are up to snuff. Had a compression fitting pop loose once and it was like Niagara Falls under the toilet. Now I keep it at medium, just in case.
“crank it up and you’ll find out real quick if your fittings are up to snuff.”
That’s the truth. I learned the hard way that “jet” mode is a gamble, especially in older homes. I used to think more pressure meant better cleaning, but after a minor flood behind the toilet (and a not-so-minor repair bill), I’m firmly in the medium camp now. It’s enough to get the job done without stressing the pipes or wasting water.
Honestly, I’ve found that dialing it back a bit is not just safer for the plumbing, but also more eco-friendly. Less water, less risk, and honestly, it’s just as effective if you give it an extra second or two. I get the appeal of max power, but for me, it’s not worth the potential headache—or the environmental impact. Sometimes “good enough” really is good enough.
