Push-fits are like the duct tape of plumbing—get you out of a jam, but you’re always a little nervous about what’s happening behind the scenes. I’ve slapped one on a copper line at 3am, half-asleep, socks soaked, and just prayed it’d hold till morning. For anything hidden in a wall, though? Nah, I’m sweating those joints or using compression every time. Had a push-fit pop off once after a year because I didn’t clean the pipe well enough—came home to a mini indoor pool. Lesson learned.
For emergencies, though, they’re a lifesaver. Just keep a couple in your toolbox and maybe a towel or two for the inevitable mess. And yeah, wet socks are the worst... but stepping on a Lego while dealing with a burst pipe? That’s next-level pain.
For anything hidden in a wall, though? Nah, I’m sweating those joints or using compression every time.
- 100% with you there. Push-fits are great in a pinch, but I just can’t trust them for stuff behind drywall.
- Had a “quick fix” with one under my kitchen sink. It held for six months, then let go at 2am—water everywhere, cat freaked out, total chaos.
- Now I keep a couple on hand, but only use them where I can see ’em. Learned to double-check pipe ends too... a little grit and they’ll fail fast.
- Stepping on a Lego mid-flood? That’s just insult to injury.
Now I keep a couple on hand, but only use them where I can see ’em.
Same here. I’ve seen too many push-fits fail when there’s just a bit of grit or a nicked pipe. I’ll use ‘em for temp fixes, but anything in a wall gets soldered every time. Not worth the risk.
I get what you’re saying, but I’ve actually had a push-fit save my bacon during a midnight leak under the kitchen sink. It held up for a couple weeks until I could get around to soldering it proper. Still, I wouldn’t trust one behind drywall either. Ever tried those compression fittings as a backup? I’ve had mixed luck—sometimes they’re solid, sometimes they drip just enough to drive you nuts.
Ever tried those compression fittings as a backup? I’ve had mixed luck—sometimes they’re solid, sometimes they drip just enough to drive you nuts.
Man, you nailed it with that. Compression fittings are like the coin toss of plumbing—sometimes you get lucky, sometimes you’re mopping up at 2am. Had one under a bathroom sink that held for months, then started weeping for no reason. Push-fits are great in a pinch, but I’m always waiting for the day they let go behind a wall... Murphy’s Law, right?