I feel like compression fittings give me more peace of mind—especially with water pressure spikes.
I totally get that. I’ve had a push-to-connect fitting under my bathroom sink for about three years now, and so far, no leaks... but I still check it every few months just in case. Compression fittings just seem sturdier to me, especially if you’re dealing with older pipes or higher pressure. Maybe it’s just habit, but I trust them more for anything that’s not easily accessible.
Compression fittings just feel more “set it and forget it,” you know? Push-to-connect is convenient, but I’ve seen them drip after a year or two—especially if someone bumps the pipe. Maybe I’m just old school, but I sleep better with compression, especially in rentals where folks aren’t always gentle. Anyone else ever had a push-fit pop off at 2am? That’s a memory that sticks...
Anyone else ever had a push-fit pop off at 2am? That’s a memory that sticks...
Man, I totally get that. Happened to me once when I was still learning—woke up to the sound of water hitting the floor. Turns out, I hadn’t pushed the fitting all the way in. Ever since then, I lean toward compression too, especially under sinks where stuff gets jostled. Push-to-connect is fast, but that “set it and forget it” feeling just isn’t the same for me.
Push-fits are handy, but I’ve seen more than one let go after a few years—especially in spots where folks store cleaning supplies and stuff gets bumped around. Compression’s not perfect either, but at least you can tighten it down if you spot a drip. Curious if anyone’s tried those new push-fit brands that claim to grip better? Or is it just the same old story with a different label? I’ve stuck with brass compression for most under-sink jobs, but maybe I’m just set in my ways...
I get where you’re coming from—compression fittings just feel more reassuring, especially when you can actually see and adjust the connection if something’s off. I’ve tried a couple of those newer push-fit brands (the ones with the extra “teeth” or whatever), and honestly, they seem a bit sturdier, but I’m still not convinced they’ll hold up long-term under a busy sink. Maybe it’s just habit, but tightening down a brass nut gives me peace of mind that plastic can’t match. Still, I guess if you’re in a pinch or working in a tight spot, push-fits have their place... just not sure I’d trust them for anything critical.