I've tried fiberglass repair kits on a laundry room sink—here's my take:
- Definitely sturdier than epoxy, held up well against water pressure.
- Blending it visually was tricky; ended up looking patchy.
- Good for utility areas, but I'd hesitate to use it in a main bathroom or kitchen sink...
Fiberglass kits can be decent for quick fixes, but honestly, I've seen a few fail after some time, especially with temperature fluctuations. Might wanna consider biting the bullet and going pro for sinks you use daily... saves headaches down the road.
I've gotta agree with the fiberglass kit skepticism here. A couple years back, I had a customer who'd patched up their kitchen sink with one of those DIY kits. Looked decent enough at first glance, but within a few months, it started peeling around the edges and water seeped underneath—ended up causing more damage than the original crack!
Honestly, for sinks you rely on daily, it's usually worth investing in a professional fix. Temperature swings, constant water exposure, and regular wear and tear can really put those quick fixes to the test. Sure, DIY kits can be tempting (and cheaper upfront), but I've seen too many folks regret going that route when they're stuck dealing with bigger issues later.
If it's just a temporary thing or a sink you rarely use, maybe give the kit a shot...but for your main sink? I'd definitely lean toward getting it done right the first time. Saves you stress and money in the long run.
I get your point, but honestly, I've had pretty decent luck with DIY epoxy kits—especially the eco-friendly ones. Patched up my bathroom sink about two years ago, and it's still holding strong. Maybe it depends on prep work and patience? If you're thorough with sanding and cleaning beforehand, these kits can surprise you. Plus, less waste than replacing the whole sink...worth considering if sustainability matters to you.
Yeah, totally agree on the prep work—makes a huge difference. I've seen DIY epoxy jobs hold up surprisingly well when people actually take their time sanding and cleaning. But honestly, I've also had to redo a few where someone rushed it or skipped steps...not fun scraping off half-cured epoxy, trust me. Bottom line, if you're patient and thorough, DIY can definitely be solid and eco-friendly too. Just don't cut corners.
